The Physics of Driver Efficiency: Where the Losses Go
An efficiency rating of 88 percent means that for every 100 watts of output power, the driver draws roughly 113.6 watts from the mains and dissipates the difference, about 13.6 watts, as heat. Efficiency is not a constant; it changes with input voltage, load, and temperature. Understanding where the losses come from explains why the number moves and why two drivers with the same label figure can behave differently in the field, especially when the load is dimmed and the fixed losses take a larger share of the total.
The losses divide into a few well-understood families. Conduction losses appear wherever current flows through a resistance: the MOSFET channel resistance, the forward voltage of the output diodes, and the winding resistance of the transformer. Switching losses occur every time the MOSFET turns on and off, because voltage and current overlap briefly during each transition, and the energy of that overlap is repeated at every switching cycle. Magnetic losses in the transformer and inductor cores come from hysteresis and eddy currents, and they grow with frequency. Capacitor ESR and the control electronics add the remainder.
Load changes which losses dominate. At full load, conduction and magnetic losses are large, and the driver usually operates near its efficiency peak. At light load, the fixed losses, the control circuit, the bias supply, and the switching losses that do not scale with output, form a larger share of total input power, so efficiency falls. A dimmed driver running at ten percent output may convert power at sixty percent efficiency or worse, which is a fact of life for dimmable systems and the reason standby and minimum-load figures matter as much as the full-load number.
Efficiency is also a thermal story. Every lost watt becomes heat inside the enclosure, and heat is what limits component life. Compare a driver at 88 percent with one at 92 percent at the same 100W output: the losses differ by about 4.5 watts, roughly 11.4 versus 8.0, and that difference shows up directly in case temperature and in the lifetime of the electrolytic capacitors. Higher efficiency is not only an energy saving; it buys thermal margin that extends the usable life and reduces the size of the heatsink the installation needs.
Because the number is regulated, its measurement is standardized. The European Ecodesign regulation 2019/2020 sets minimum efficiencies for separate control gear and prescribes how they are measured, and the US Department of Energy Level VI scheme does the same for external power supplies. A compliant product carries markings and documentation that tie the efficiency claim to a defined test method, and market surveillance authorities can audit against those same conditions. The takeaway for the buyer is that an efficiency value is only as good as the conditions it was measured under.
Ramp Times and Response Delay: How Fast a 0-10V System Reacts
Surge Protection Inside and Outside the Driver: MOVs, TVS and Coordinated SPDs
Related Article