NEC Class 2 Control Circuits: Wiring the 0-10V Pair Correctly
The 0-10V control pair is a low-voltage, low-energy circuit, and in North American installations it is usually wired as a Class 2 circuit under the National Electrical Code. The classification is not a formality: it determines which cables may be used, how the circuit must be separated from mains wiring, and what a controller is allowed to supply. Getting it wrong turns a simple dimming installation into a code violation at inspection.
Class 2 is defined by its limits. The circuit operates at a voltage and a power level low enough that a fault is unlikely to cause a fire or a shock, and the supply must be a listed Class 2 power source. Typical limits are 30 volts and a power table that depends on the voltage and the application. Above those limits the circuit becomes Class 3, with different wiring rules, and above that it is treated as a mains circuit.
Wiring follows from the classification. Class 2 cables are permitted in exposed runs and can be installed without the enclosures required for mains wiring, but they must not be mixed with mains conductors in the same raceway unless the cable is listed for the combination. The separation matters because a fault in the mains wiring could energize the control pair, and the low-voltage insulation was never designed for that voltage.
The controller must supply the class. A 0-10V wall station or a lighting control panel that provides the control voltage has to be a listed Class 2 source if the circuit is to be treated as Class 2. A controller fed from a mains-derived supply without the listing changes the classification of the whole control circuit, and the inspector will ask for the listing before accepting the installation.
The practice on site is to keep the control pair separate and identifiable. Use the cable type specified for Class 2, keep the runs away from dimmers and ballasts that inject noise, and terminate with the connectors the manufacturer specifies. Where a control pair crosses a mains compartment, the crossing should respect the separation rules, and the installer should not improvise a splice that mixes the two circuits.
For a driver like the PV100, the 0-10V input is a SELV control input, and the installation should follow the Class 2 rules for the control circuit even though the driver input side is mains. The distinction is between the power circuit and the control circuit, and they are governed by different articles. A project that treats them as one circuit will usually pass the electrical test and fail the inspection.
Inspection failures often come from small details: a control cable run in the same conduit as the mains, a splice made with wire nuts instead of a listed connector, or a controller whose listing covers a different voltage class. Each of these is easy to correct before the inspection and expensive after it, and each is visible in a walk-through.
Documentation helps. Keep the Class 2 listing for the controller and the cable specification in the project file, and mark the control pair at the panel. An inspector who can see the classification on the drawings is less likely to question the installation on site, and the next technician inherits a system that can be maintained without guesswork. A labelled panel also shortens fault finding, because it is immediately clear which pair is the control circuit and which is the mains feed.
Lumen Maintenance: L70, L90 and the TM-21 Extrapolation
Flicker Metrics: Percent Flicker, Flicker Index and IEEE 1789
Related Article