Synchronous Rectification on a 24V Output: Gains, Timing and Risks
On a 24 volt output the rectifier is a significant loss centre. A Schottky diode with a forward drop of about half a volt dissipates that drop multiplied by the output current: at four amperes, roughly two watts, which is more than two percent of a 96 watt output. Replacing the diode with a MOSFET that conducts through its channel resistance reduces the loss to the current squared times the on-resistance, and at modern device resistances that can be a fraction of the diode loss.
The idea is simple, the implementation is not. A synchronous rectifier needs a gate drive referenced to the source, a controller that knows when to turn the MOSFET on and off, and protection against the case where the body diode conducts before the channel is enhanced. The timing must account for the dead time between the primary switch and the secondary switch, because a shoot-through would short the output through both devices.
The benefit depends on current and voltage. At low output voltage the diode drop is a large fraction of the output, so synchronous rectification wins clearly. At high output voltage the drop is a smaller fraction and the added complexity may not pay. At light load the gate drive and switching losses of the synchronous device can exceed the diode loss, which is why many designs disable synchronous rectification below a threshold and revert to diode conduction or burst mode.
Reliability needs attention. The synchronous MOSFET can fail short, which puts a direct short across the output, and the protection must detect and clear it. The gate drive must survive the rate of change of voltage at the switching node, and the controller must handle startup and shutdown transitions without glitches. A design that saves two watts but adds a failure mode is not a good trade, and the protection around the synchronous stage is part of the evaluation.
The thermal benefit is often the real reason for the change. Removing two watts from a small enclosure lowers the case temperature, which extends capacitor life and allows a smaller heatsink or a plastic housing without vents. In a sealed plastic case rated for 40 degrees ambient, that thermal margin can matter more than the electrical efficiency number, because it decides whether the product stays inside its rating on a hot ceiling.
For the PV100, the 24 volt output and the plastic housing make the rectifier loss a design constraint rather than a detail. Whether the product uses a Schottky diode or a synchronous stage, the datasheet efficiency figure at rated load reflects that choice, and the buyer can compare it with the case temperature rating. A product that claims high efficiency but runs hot is usually losing the difference somewhere the brochure does not mention.
Gate drive timing is usually derived from the primary switch signal, with a delay that allows the secondary current to commutate before the synchronous device turns on. Too little delay and the body diode conducts, wasting the benefit and heating the device; too much delay and the diode conducts for longer, which is safe but less efficient. The controller datasheet usually gives a recommended window.
Cost is the counterweight. A synchronous stage adds a MOSFET, a gate driver and sensing, and it complicates the layout because the switching node is noisy. For a 24 volt output at modest current the diode may be the better commercial choice, and a point or two of efficiency may not justify the extra failure modes in a low-cost product.
Multiple Drivers on One 0-10V Channel: Doing the Current Budget
The RCD Clamp: Protecting the Primary Switch Without Wasting Power
Related Article