Multiple Drivers on One 0-10V Channel: Doing the Current Budget
A 0-10V controller does not supply a voltage out of nothing; it supplies a control voltage and a limited current. Each driver connected to that control pair draws a small current to operate its dimming input, and the total must stay inside the controller rating. Exceed it and the control voltage droops, the dimming level falls, and the whole zone misbehaves in a way that looks like a driver fault but is actually a budget problem.
The numbers are small but they add up. A typical driver input may sink one to two milliamps, and a controller may be rated to source ten, twenty or fifty milliamps depending on the model. A controller rated at twenty milliamps can serve ten drivers at two milliamps each with no margin, and a project with fifteen drivers on the same pair will see the control voltage fall as more units are connected. The calculation is simple and it belongs in the design stage, not in commissioning.
The direction of current matters. In an ANSI C137.1 system the driver sinks current and the controller sources it, so the controller rating is a source rating. Some controllers are designed to work with a passive potentiometer instead, and in that arrangement the current comes from the controller supply through the potentiometer. Mixing a sink-only driver with a controller that expects a passive input produces a signal that does not track the setting.
The practical fix is to check the budget before the order. Read the controller output rating, read the driver input current, and divide. Where the count is close to the limit, split the zone across two controller channels, or use a controller with a higher current capability, or add a signal booster that buffers the control voltage for a large group. None of these is expensive; discovering the problem at commissioning is.
Commissioning confirms the budget. Measure the control voltage at the controller and at the driver farthest from it, with all drivers connected and set to full output. A drop of a volt or more between the two points means the wiring or the current budget is marginal. Measure again at minimum output, because the current drawn by the input can change with the dimming level in some designs.
For a project using the PV100, the dimming input current is stated in the datasheet, and the controller budget should be checked against the number of drivers per channel. A pair of control wires serving forty drivers is convenient on the drawing and often wrong in the field. The count per channel is one of those details that never appears in a lighting layout but decides whether the dimming works on the day of handover.
Long control runs add their own limit. The control pair carries a small current, and the resistance of a long cable produces a voltage drop between the controller and the farthest driver. Even when the current budget is fine, a hundred metres of unshielded cable can lose enough voltage to shift the dimming level, which is why the measurement at the far end matters as much as the calculation.
Some controllers include a current limit that folds back the output when the load exceeds the rating, which protects the controller but makes the symptom confusing: the first drivers dim correctly and the last ones sit at minimum. Recording the number of drivers per channel on the as-built drawing prevents the next technician from repeating the mistake.
Emergency Lighting and 0-10V Drivers: Two Functions, Two Sets of Rules
Synchronous Rectification on a 24V Output: Gains, Timing and Risks
Related Article