Color Shift During Dimming: Why White Light Changes as Current Falls
Dimming changes the current through the LEDs, and the color of the light changes with it. The shift is small but real, and it becomes visible where white surfaces, merchandise or skin tones are judged against a reference. Understanding why it happens helps a specifier ask the right question, because a datasheet rarely states chromaticity against dimming level unless the product was designed for that market.
The mechanism is in the LED package. A white LED is a blue pump covered with phosphor, and the phosphor converts part of the blue light into longer wavelengths. As the drive current falls, the blue emission and the phosphor conversion do not scale identically, so the balance between blue and yellow shifts. The result is usually a small change in correlated color temperature and a shift in the chromaticity coordinates, in a direction that depends on the phosphor formulation.
Temperature adds a second effect. At low current the junction runs cooler, and the emission wavelength of the blue pump shifts with temperature, as does the phosphor efficiency. Constant-current dimming keeps the current per LED defined, but the junction temperature still falls because less power is dissipated, so the shift is not eliminated; it is only made more predictable than in a system where the current itself is uncertain.
The magnitude is measured in MacAdam ellipses or in color difference units. A shift of two to three steps is noticeable to a trained eye on a white wall and usually acceptable in general lighting, while a shift of five steps or more reads as a color change rather than a dimming. Premium architectural and retail projects often specify a limit, and the limit should be tied to the dimming range that will actually be used.
Mitigation is partly electronic and partly optical. Keeping the LED current within the bin the module was designed for avoids the worst of the shift, which is another argument for constant-current modules on a constant-voltage bus. The dimming curve matters too: a linear voltage-to-current mapping spends little time at very low currents, while deep dimming to one percent pushes the module into the region where the shift is largest.
For a project, the right question is specific: what is the chromaticity shift between full output and the minimum dimming level, measured on the actual module. The driver sets the current, so a driver that holds its output accurately and dims smoothly supports the module performance, while a driver with a coarse or non-monotonic dimming curve makes the shift visible as a jump. The PV100 dims linearly through its 0-10V interface, which keeps the electrical side of the problem under control.
Binning adds a third variable. LEDs are sorted into bins by flux and by chromaticity, and a module built from a tight bin holds its color better across the dimming range than one built from a wide bin. When a project specifies color consistency, the bin and the dimming behaviour belong in the same requirement, because a tight bin at full output can still drift at one percent.
The dimming curve type matters here too. A logarithmic curve spends more of its travel in the low range where the shift is largest, while a linear electrical curve spends less. Neither is wrong, but the choice changes how often occupants see the colour change, and the specification should describe the curve rather than only the dimming range. The minimum output level belongs in the same document, because that is where the colour change is most likely to be seen.
Terminals and Connectors: Torque, Contact Resistance and Thermal Cycling
Emergency Lighting and 0-10V Drivers: Two Functions, Two Sets of Rules
Related Article