Burn-In and Production Testing: Screening Out the Early Failures
Most electronic failures happen early. The bathtub curve describes three regions: a high failure rate in the first hours, a low and roughly constant rate in the middle, and a rising rate at the end from wear-out. Burn-in attacks the first region by running every unit long enough for the weak ones to fail in the factory rather than in a ceiling. It is a screening step, not a quality improvement step, and the distinction matters.
The conditions are chosen to accelerate latent defects without consuming useful life. A typical burn-in runs the unit at rated load, often at an elevated ambient such as 40 to 60 degrees, for a period from a few hours to a day. The unit is tested before and after, and sometimes monitored during, so that a drift in output voltage or current is caught even when the unit still functions. The elevated temperature is a stress, and the duration must be balanced against wear.
What burn-in catches is specific. Marginal solder joints that open when warm, electrolytic capacitors with high leakage, semiconductors with weak gate oxide, and connectors with poor contact resistance. These defects are present from manufacture but only appear under stress, and a short functional test at room temperature passes them. A burn-in with a load and a temperature soak finds them before they reach a customer.
The economics are a tradeoff. Running every unit costs test time, chamber capacity and energy, and it consumes a small part of the product life. Some manufacturers burn in a sample and rely on process control for the rest, which is cheaper but less protective. Others use a highly accelerated stress screen with short duration and high stress, which finds defects quickly but requires a validated profile to avoid damaging good units.
Records make the difference visible. A burn-in without data is a ritual. The serial number, the test conditions, the before and after measurements and the failure disposition should be recorded, so that a field failure can be traced to a production date and a batch. When a supplier cannot show burn-in records, the buyer is relying on reputation rather than on evidence.
For the PV100, the production test strategy is part of what the buyer should ask about, alongside the certificates. A product that is functionally tested at the end of the line and sampled for burn-in is normal for the price class; a product with a documented full burn-in is more expensive and more predictable. The right question is not whether burn-in exists, but what it covers and what it records.
The screen should be designed around the failure modes, not applied as a generic soak. A product with a known weakness in the output capacitor benefits from a burn-in at elevated temperature with full load, while a product with connector problems needs a vibration or handling step. The screen that finds the defects in a particular design is chosen after the design failure mode analysis, not before. The screen profile therefore belongs in the product specification, not only in the factory.
Yield data closes the loop. A burn-in that consistently fails two percent of units is telling the process something, and a supplier that tracks the failure mode and fixes the cause improves over time. A supplier that treats burn-in as a filter and never investigates the rejects is relying on the screen to hide a process problem, which works until the volume grows.
Wireless 0-10V Adapters: Networking an Installed Base
Vibration and Mechanical Reliability: What Solder Joints Endure
Related Article