Flammability of Driver Enclosures: UL 94 and the Glow-Wire Tests
A driver housing is usually plastic, and plastic burns. The fire safety of the product depends on the material chosen and on the tests that material has passed, and those tests are written into the safety standards for luminaires and control gear. Two test families matter: the UL 94 vertical burn test, which describes how a small specimen behaves when ignited, and the glow-wire tests, which simulate a hot component or a faulty connection inside the product.
UL 94 classifies materials by their behaviour in a vertical burn. A V-0 specimen extinguishes within ten seconds after the flame is removed, and no burning material drips onto the cotton below. V-1 allows up to thirty seconds with no dripping, and V-2 allows the same time with dripping that may ignite the cotton. For enclosures the classes 5VA and 5VB apply to larger specimens and describe resistance to burn-through.
The glow-wire test approaches the problem from the other direction. A glowing wire at a defined temperature is applied to the specimen, and the test records whether the material ignites, how long it burns and whether flaming droplets appear. IEC 60695-2-11 covers the glow-wire flammability test for finished products, and the related parts cover glow-wire ignition temperature and the glow-wire flammability index for materials.
The two families answer different questions. UL 94 asks how a material behaves once a flame exists. The glow-wire test asks whether a hot element or a poor connection can start a fire in the first place, which is the more realistic failure mode inside a driver. A product can pass one and fail the other, so the safety file usually contains both, and a certificate that cites only one is incomplete for a mains-powered enclosure.
Temperature and thickness change the answer. A material rated V-0 at one wall thickness may be rated V-2 at a thinner section, because the specimen geometry affects heat transfer and the supply of fuel. The housing wall thickness is therefore part of the flammability claim, and a product moulded thinner than the tested sample no longer carries the rating. Buyers rarely check this, and it is one of the quieter ways a certificate and a product diverge.
Flame retardants carry costs beyond the test report. Halogenated systems are effective but face disposal and environmental pressure, while halogen-free systems often need higher filler content, which affects moulding, mechanical strength and UV stability. The choice shows up in the housing colour, the surface finish and the impact resistance, and a product that meets the flammability rating while cracking in service has traded one problem for another.
For a project, the evidence is the certificate and the material declaration. The certificate should name the standard, the class and the specimen thickness, and the declaration should identify the material and its rating. A marking on the housing is useful but not sufficient. Where the housing is part of a fire-rated luminaire, the luminaire certificate governs, and the driver material must match what was tested.
For the PV100, the plastic housing carries the flammability performance required by the safety standard behind its CE marking, and the rating applies to the housing as produced. An installation that modifies the housing, drills extra holes or replaces the enclosure with a different material removes that claim. The enclosure is part of the safety design, not a cosmetic shell.
One practical point closes the loop: the flammability claim is tied to the moulding tool and the resin grade. A supplier that changes resin to reduce cost, without repeating the test, invalidates the file even though the part looks the same from outside.
Is the 0-10V Input Isolated? Why the Answer Changes the Wiring Rules
Earth Leakage Current: Why a Bank of LED Drivers Trips the RCD
Related Article